FITTING INSTRUCTIONS
- Find a suitable flat location on the dash to mount the Dimmer Controller.
- If required pre-drill a hole for the cable to pass through the dash or alternatively pass the cable through an existing opening.
- Using either the 3M double sided tape, or M4 screws, fix the controller bracket to the dash.
- Pass the two wires through a grommet in the vehicle firewall making sure the cables will not rub on any sharp edges.
- Connect the 4 pin LEDLinkTM twist lock plug to the matching socket from your Roadvision Next Generation LED Light Bar.
- For vehicles fitted with HB3 or H4 bulbs, plug the relevant piggy back connector into the high beam lead from the dimmer controller. (part numbers; HB3 – RPBCHB3 or H4 – RPBCH4 both sold separately).
- Unplug the vehicles head lamp plug (high beam) from the back of one of the head lamp bulbs and plug the piggy back connector into both the globe and vehicle harness.
- For vehicles where a piggy back connector cannot be installed, identify the positive high beam feed and connect the red wire, connect the black wire to the negative feed to the high beam. Ensure to solder or use an appropriate crimp terminal and insulate the bare wires with heat shrink or electrical tape.
- Connect the Roadvision Next Generation light bars 2 pin Deutsch or ATP plug directly to the battery with an appropriate fuse installed on the positive feed. (part numbers; Deutsch – RPCDT3M or ATP – RPCATP3M both sold separately).
- Secure all access wire to the vehicle.
